WTB: Telecaster neck (CV, standard squier, unbranded etc)

Creed_Clicks

Before I go to the fleabay, thought I might check here first. Would like to go a bit higher quality that a bullet neck, so maybe a CV, or something. Unbranded etc...

paulnb57

@Creed_Clicks ;;
OK lets try again, Ive had a scratch around and have there two jokers
I have too many guitars already and these wont get used
The top one was an ebay purchase years ago, it was used on an early project and is fine, but its been in storage for ages, it has an issue, the top e tuner hole was drilled 1mm oversize at the factory, 11mm instead of 10....wrap some masking tape round the body of the tuner where it goes through the hole and its fine, med jumbo ish, a bit of flame, heel truss rod adjustment, no nut, quite a thick poly finish, small cracks in the finish at tje tuner screw holes, not too bad a budget neck....
30quid mailed

Bottom one is by GSP Basses, is finished in thin Nitro, med jumbo, two way truss rod, Locking, staggered tuners
100quid mailed...

paulnb57

Creed_Clicks

@paulnb57 no pics, I see you edited the post from the one earlier?

paulnb57

@Creed_Clicks ;Yep Im a retard...Im on it!

skinfreak

Justin case there is this one on fleabay; https://www.ebay.co.uk/itm/233544819296

lysander

@paulnb57 would you mind measuring the nut width and thickness of the GSO neck ?
Would be interested if it’s the wide / thin type

paulnb57

@lysander  neck width is just shy of 1.7 inches wide at the nut and about .980inch deep at first, twelfth and onward! Not wide n thin!

lysander

Ok thanks for checking @paulnb57 !