Sorted for my budget tele body, which will be wudtoned and very pretty it will be.
So now I need a tele neck, but the only unfinished ones I can find are a 50 quid rosewood boarded job from agc guitars. Nout wrong with that, but I was wondering if there was any more choice out there?
Basically looking for a maple/maple or maple/rosewood neck for relatively little to buy in a couple of months, when the body will be completed. No idea what agc guitars are like, but I'd want a good truss rod and unfinished so I can wudtone it to taste, and possibly finish with tru oil and a shit ton of buffing, as well as some sandpaper to the fingerboard edge for a slightly worn feel.
Comments
And raw, unfinished wood so I can have a go at finishing it!
Your life will improve when you realise it’s better to be alone than chase people who do not really care about you. Saying YES to happiness means learning to say NO to things and people that stress you out.
https://www.facebook.com/grahame.pollard.39/
I've just been fleeced for 2 new tyres!
I'll inquire when I've got the dollar though. Otherwise, a tele neck with a cbs headstock and ebony board is my likely purchase in a few months time!
The only thing that was slightly disappointing on them is that the fret slots are cut deeper than the fret tang so there is a bit of an unsightly gap underneath each fret.
Good quality neck though.
(formerly miserneil)
Probably the best route for me though. I don't want too fat, I only have little hands. I like a generic c profile with a radius of between 9.5 and completely flat. Telecaster means I'll probably get a 10 or 12 inch...