Morning all
Just wired up my guitar & the bridge coil splits to the inner coil.. I wanted outer
So, I'm trying to avoid ripping it apart again & flipping the pickup (I've fitted them with the baseplate wire holes closest to wiring channels so I'm not sure the wires would be long enough when flipped)
Pickup is a dimarzio tone zone....Can I just switch the red (switch + ) & green wire (pot ground) on the bridge pickup???
Or am I going to end up with out of phase shyte going on?
Cheers as usual in advance for the n00b advice
it's a minor annoyance but might as well try to sort it
Comments
If the split connection from the switch goes to ground, connect it to the pickup hot instead.
"Take these three items, some WD-40, a vise grip, and a roll of duct tape. Any man worth his salt can fix almost any problem with this stuff alone." - Walt Kowalski
"Only two things are infinite - the universe, and human stupidity. And I'm not sure about the universe." - Albert Einstein