It looks like you're new here. If you want to get involved, click one of these buttons!
Subscribe to our Patreon, and get image uploads with no ads on the site!
Base theme by DesignModo & ported to Powered by Vanilla by Chris Ireland, modified by the "theFB" team.
Comments
I fucking hate wallwarts though- would much rather IEC connections on everything.
Studio: https://www.voltperoctave.com
Music: https://www.euclideancircuits.com
Me: https://www.jamesrichmond.com
Each output is isolated. Each can be set to 9,12,15 or 18V (power OP dependant. 500ma at 12v, 660 at 9v etc). Can be centre pos or neg (two different cables depending - they just switch the pins int he cable). You can connect as many to a single synth as you can physically fit in the connectpor (which is phono at the blockl end) but realistically 3 is the limit. Cioks do doublers, but I made a 3 way that works perfectly for 1.5 amps.
The DC7 provides 7 outputs PLUS a 5V on USB (again isolated) - and also has a power out that can feed the DC04 which adds a further 4 oputputs from the same IEC connector (obviously connected to the DC07). They are surprisiongly small... approx 6" x 3" x 1" for the o7 - and half that for the 4.
They aren’t cheap, though.
https://i.imgur.com/D79XS1V.jpg
https://i.imgur.com/NbTGMci.jpg
neet fit,,, 3 way cable - then just plug a regular Cioks cable into single phone end - with the barell end going into the synth.
The centre NEGATIVE ones are black ends, the centre POSITIVE ones are red ends.
Also check power you need. Most Synths are 12v, and you get 500Ma from each outlet at that voltage. most synths Ive seen use 1 Amp (some .5 some 1.5 but most are 1A) so youll need the doublers. Again the Cioks are readily available and cheep (they are grey ends) BUT actually you can use ANY twin male to single female Phone cable.....