Loose threaded insert on tail piece

uncledick

I'm refurbing my Heritage H150 and one of the threaded bushes on the tailpiece is spinning when I try to tighten the screw.  The hole is basically still 'round' but I'd like a recommendation on what glue to use to hold the thing in.

ICBM

High strength epoxy.

When you do it, screw the post all the way down into the insert, and put a little grease on the end of it - that will stop glue being forced up inside the thread or sticking to the post.

uncledick

ICBM said:

High strength epoxy.

When you do it, screw the post all the way down into the insert, and put a little grease on the end of it - that will stop glue being forced up inside the thread or sticking to the post.

Thanks