It looks like you're new here. If you want to get involved, click one of these buttons!
Subscribe to our Patreon, and get image uploads with no ads on the site!
I was using my Boss RC3 earlier today. When I stomped on it to start the loop, it showed an 'FL' error code on the screen.
I could not clear this code, so I switched it off. When I switched it back on, it flashed 'Er' on the screen.
I have tried a factory reset, but was unable to complete the process- it just showed another error code, 'dN'.
The manual suggests that this means the unit needs to be returned for repair. However, I've had similar issues in the past and have been able to restore the pedal eventually. It's been running trouble free for quite a while but I can't seem to clear the error this time.
Has anyone experienced similar issues?
Base theme by DesignModo & ported to Powered by Vanilla by Chris Ireland, modified by the "theFB" team.
Comments
Worth a try, but no luck unfortunately. I'm looking for a Boss approved repairer now :-(
Failing that, I have one I’m not really using that I might sell...
"Take these three items, some WD-40, a vise grip, and a roll of duct tape. Any man worth his salt can fix almost any problem with this stuff alone." - Walt Kowalski
"Only two things are infinite - the universe, and human stupidity. And I'm not sure about the universe." - Albert Einstein
I suspect the memory has failed. Not sure whether it is an economic repair or not. It has happened a couple of times before and some messing about with factory resets etc has worked. But not this time.
For about 3 minutes. Then it crapped out again :-(
Back to Roland/Boss I go.