Low-profile XLR plugs?

stickyfiddle

Anyone got a good recommendation for these? I'm using a Helicon Talkbox on my board and plugging cables in to the middle of my board is really annoying, so I'm thinking about options to hardwire the pedal into a patchbay so I can just plug the in- & outbound cables to the side or top edge of the board. 

stickyfiddle

...I guess that's a no then?  

CarbonCopy

https://www.canford.co.uk/CANFORD-LOW-PROFILE-XLR-CABLE-CONNECTORS

A quick Google revealed these.

stickyfiddle

Yeah those are the most likely ones from a bit of googling. Just wondering if anyone had ever used any could recommend for/against but I guess not!

Sporky

Not used those, but Canford stuff tends to be perfectly decent. 

Stratavarious

https://www.designacable.com/van-damme-neutrik-angled-male-xlr-to-angled-female-xlr-cable.html?gad_source=1&gclid=Cj0KCQjw8J6wBhDXARIsAPo7QA-G4B9nLm-HKQNsvn9E56pefwtJgwt88yG36qRCLkII9382-FcoC1oaAr6JEALw_wcB

If you mean angled.. I use Neutrik for everything.  These can be configured for different angles. 

stickyfiddle

Stratavarious said:

https://www.designacable.com/van-damme-neutrik-angled-male-xlr-to-angled-female-xlr-cable.html?gad_source=1&gclid=Cj0KCQjw8J6wBhDXARIsAPo7QA-G4B9nLm-HKQNsvn9E56pefwtJgwt88yG36qRCLkII9382-FcoC1oaAr6JEALw_wcB

If you mean angled.. I use Neutrik for everything.  These can be configured for different angles. 

Sadly they wont' fit on a pedalboard any better than the standard straight ones I have already!  

springhead

You can of course make your own. Cut down the body to reduce the length. File a notch so the cable can exit at a right angle and then when soldered in fill up the hole with hot glue, epoxy or whatever. You might get them a little bit shorter than the Canford ones that way. I’ve done that for a pair of monitor speakers on my desk that I wanted to sit as close the the wall as possible.