It looks like you're new here. If you want to get involved, click one of these buttons!
Subscribe to our Patreon, and get image uploads with no ads on the site!
Morning all
I've just purchased a switcher pedal to make my life a little easier on the old pedal stomping front.
I've been using the cheap Stagg cables for a while, but they do tend to break fairly easily and I was left in a bit of a pickle last week when they did,
Just wondering, for those that use switching pedals, what patch cables do you use? I've made some before with the solderless kits, and in all honesty I'd rather avoid that as they are a right faff. I can't solder either, so that's off the table.
Would appreciate your suggestions
Feedback can be found here http://www.thefretboard.co.uk/discussion/comment/908933#Comment_908933
Base theme by DesignModo & ported to Powered by Vanilla by Chris Ireland, modified by the "theFB" team.
Comments
If not, which switcher? The layout of the jack sockets will make a difference to what will fit...
Don't talk politics and don't throw stones. Your royal highnesses.
Simply put bud, my plate is far too full to try add something else to it.
It's a disaster area DPC5
Feedback can be found here http://www.thefretboard.co.uk/discussion/comment/908933#Comment_908933
Which is why I said I'd rather avoid doing them
Feedback can be found here http://www.thefretboard.co.uk/discussion/comment/908933#Comment_908933
The solderless plugs are usually designed small for just such a situation, but pre-made patch cables are often right angled.
Don't talk politics and don't throw stones. Your royal highnesses.
cheers for the advice bud, I'll wait to get the DPC5 first and then see what I'm up against
Feedback can be found here http://www.thefretboard.co.uk/discussion/comment/908933#Comment_908933
The other option, though probably a bit more expensive would be to get it all laid out, then measure and have someone make a bunch of cables up for you.
Theres some people on here I believe that can do that.
http://tinypic.com/r/2mgt749/9
squareplugs
These will fit in the back of the dpc if space is an issue and seemed to be much better quality than the cheapo pancake jacks. They are not cheap though
Feedback can be found here http://www.thefretboard.co.uk/discussion/comment/908933#Comment_908933
R.
Eqd Speaker Cranker clone
Monte Allums TR-2 Plus mod kit
Trading feedback: http://www.thefretboard.co.uk/discussion/60602/
Feedback can be found here http://www.thefretboard.co.uk/discussion/comment/908933#Comment_908933
I can make patch cables for you (soldered) but personally I've always used Lava solderless for my pedal boards (I had a G2 for a couple of years).
R.
Eqd Speaker Cranker clone
Monte Allums TR-2 Plus mod kit
Trading feedback: http://www.thefretboard.co.uk/discussion/60602/