Wiring help needed please!

Headphones

Is that intended to be the mains inlet/IEC beside the two jack sockets?   A bit of separation between mains and signal is usually, well, wise.

I trust the safety and protection points from earlier will already have been grasped, so need not be repeated (though it doesn't look like you've any cover plates there).

Gagaryn

mardymusic said:

I wanted an iec mounted on the side of the board for because I think it just looks neater. Also a thicker cable is less likely to get snagged etc.
the picture I put on today I think shows a little of the work in progress board to give you an idea. 

Then simply mount a normal three pin socket to the underside of the board - wire that to the IEC and plug the supplied power supply into the socket. Simples. :-)

mardymusic

I did think of that as an option but wouldn't fit with the large supplied power supply. 
All sorted and working great now though thanks.