I'm looking for some help to wire up a slightly different cabronita wiring scheme. The idea is to have just volume and tone controls with no selector switch. The neck pickup will be on by default, but pulling the cts push pull pot into the up position will bring in the bridge pickup in parallel.
As far as I understand it I just need to wire the neck pickup up to the volume and tone as if it were a single pickup guitar. However I’m unsure how to wire the bridge pickup to the push pull to bring it into the circuit.
can anyone help?
Comments
Simple To Service adds unnecessary unreliability by running the neck pickup through switching contacts when there's absolutely no need to.
"Take these three items, some WD-40, a vise grip, and a roll of duct tape. Any man worth his salt can fix almost any problem with this stuff alone." - Walt Kowalski
"Only two things are infinite - the universe, and human stupidity. And I'm not sure about the universe." - Albert Einstein
I sketched it out that way to minimise signal leakage through the internal contacts of a cheap push-pull pot.
"Take these three items, some WD-40, a vise grip, and a roll of duct tape. Any man worth his salt can fix almost any problem with this stuff alone." - Walt Kowalski
"Only two things are infinite - the universe, and human stupidity. And I'm not sure about the universe." - Albert Einstein